flexfax: Totally Stumped...

[Andy Moskoff <abm@ftel.net>]

Hi:

I'm getting an "Unspecified Transmit Phase B error; too many attempts to send"
error using hylafax4.0pl2 on RedHat 5.0 with a U.S. Robotics Sportster 
56k Faxmodem (its recognized as USROBOTICS SPORTSTER V.34+ FAX). 

I noticed that I didn't even get an error code from the hang up. However,
I'm getting some garbage apparently.  

I've looked through the troubleshooting section and FAQ and found nothing
about this error. Could someone point me in the right direction? Thanks.

Here's the session trace:



Your facsimile job to X.XXX.XXX.XXXX failed because:
    Unspecified Transmit Phase B error; too many attempts to send

    ---- Transcript of session follows ----

Apr 11 22:35:30.02: [ 1379]: SESSION BEGIN 00000006 XXXXXXXXX
Apr 11 22:35:30.02: [ 1379]: SEND FAX: JOB 6 DEST X.XXX.XXX.XXXX COMMID 00000006
Apr 11 22:35:30.02: [ 1379]: DELAY 2600 ms
Apr 11 22:35:32.63: [ 1379]: <-- [17:ATE0V1Q0X4S0=0H0\r]
Apr 11 22:35:32.77: [ 1379]: --> [16:ATE0V1Q0X4S0=0H0]
Apr 11 22:35:32.77: [ 1379]: --> [2:OK]
Apr 11 22:35:32.77: [ 1379]: <-- [32:ATS8=2S7=60&H1&I0&R2S13=1&D2&C1\r]
Apr 11 22:35:32.91: [ 1379]: --> [2:OK]
Apr 11 22:35:32.91: [ 1379]: <-- [14:AT+FCLASS=2.0\r]
Apr 11 22:35:33.05: [ 1379]: --> [2:OK]
Apr 11 22:35:33.05: [ 1379]: <-- [9:AT+FLO=2\r]
Apr 11 22:35:33.19: [ 1379]: --> [2:OK]
Apr 11 22:35:33.19: [ 1379]: <-- [9:AT+FPP=0\r]
Apr 11 22:35:33.33: [ 1379]: --> [2:OK]
Apr 11 22:35:33.33: [ 1379]: <-- [9:AT+FBO=0\r]
Apr 11 22:35:33.47: [ 1379]: --> [2:OK]
Apr 11 22:35:33.47: [ 1379]: <-- [10:AT+FCT=30\r]
Apr 11 22:35:33.61: [ 1379]: --> [2:OK]
Apr 11 22:35:33.61: [ 1379]: <-- [15:AT+FNR=1,1,1,1\r]
Apr 11 22:35:33.75: [ 1379]: --> [2:OK]
Apr 11 22:35:33.75: [ 1379]: <-- [9:AT+FIE=0\r]
Apr 11 22:35:33.89: [ 1379]: --> [2:OK]
Apr 11 22:35:33.89: [ 1379]: <-- [23:AT+FCC=1,5,2,2,0,0,0,0\r]
Apr 11 22:35:34.03: [ 1379]: --> [2:OK]
Apr 11 22:35:34.03: [ 1379]: <-- [5:ATM0\r]
Apr 11 22:35:34.16: [ 1379]: --> [2:OK]
Apr 11 22:35:34.16: [ 1379]: <-- [14:AT+FCLASS=2.0\r]
Apr 11 22:35:34.40: [ 1379]: --> [2:OK]
Apr 11 22:35:34.40: [ 1379]: <-- [9:AT+FLO=2\r]
Apr 11 22:35:34.64: [ 1379]: --> [2:OK]
Apr 11 22:35:34.64: [ 1379]: <-- [9:AT+FPP=0\r]
Apr 11 22:35:34.88: [ 1379]: --> [2:OK]
Apr 11 22:35:34.88: [ 1379]: <-- [9:AT+FBO=0\r]
Apr 11 22:35:35.12: [ 1379]: --> [2:OK]
Apr 11 22:35:35.12: [ 1379]: <-- [10:AT+FCT=30\r]
Apr 11 22:35:35.36: [ 1379]: --> [2:OK]
Apr 11 22:35:35.36: [ 1379]: <-- [15:AT+FNR=1,1,1,1\r]
Apr 11 22:35:35.60: [ 1379]: --> [2:OK]
Apr 11 22:35:35.60: [ 1379]: <-- [9:AT+FIE=0\r]
Apr 11 22:35:35.84: [ 1379]: --> [2:OK]
Apr 11 22:35:35.84: [ 1379]: <-- [23:AT+FCC=1,5,2,2,0,0,0,0\r]
Apr 11 22:35:36.08: [ 1379]: --> [2:OK]
Apr 11 22:35:36.08: [ 1379]: <-- [20:AT+FLI="A. Moskoff"\r]
Apr 11 22:35:36.32: [ 1379]: --> [2:OK]
Apr 11 22:35:36.32: [ 1379]: DIAL XXXXXXXXXXX
Apr 11 22:35:36.32: [ 1379]: <-- [16:ATDTXXXXXXXXXXX\r]
Apr 11 22:35:48.86: [ 1379]: --> [4:+FCO]
Apr 11 22:35:50.62: [ 1379]: --> [21:+FNF:+FIS:1,3,0,2,1,]
Apr 11 22:35:50.62: [ 1379]: REMOTE NSF "+FIS:1,3,0,2,1,"
Apr 11 22:35:50.62: [ 1379]: --> [39:,0,458387"+FIS:1,5,0,2,1,0,0,3�������]
Apr 11 22:35:50.98: [ 1379]: --> [42:�������������� ������� �
���nnnnnnnnnnnnn]
Apr 11 22:35:51.36: [ 1379]: --> [67:nnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnn����������������]
Apr 11 22:36:31.36: [ 1379]: REMOTE HANGUP: Unspecified Transmit Phase B error (code 20)
Apr 11 22:36:31.36: [ 1379]: SEND FAILED: Unspecified Transmit Phase B error
Apr 11 22:36:31.36: [ 1379]: SEND FAILED: Unspecified Transmit Phase B error; too many attempts to send
Apr 11 22:36:31.36: [ 1379]: <-- [5:ATH0\r]
Apr 11 22:36:31.59: [ 1379]: --> [4:ATH0]
Apr 11 22:36:31.59: [ 1379]: --> [2:OK]
Apr 11 22:36:31.59: [ 1379]: SESSION END


--------------------------------------------------------------
Andy Moskoff                               email: abm@ftel.net  
Intelligent Systems Solutions