Re: flexfax: Failure to train at 2400 bps or +FMINSP value

[Tobias Richter <tsr@cave.isdn.cs.tu-berlin.de>]

You (tim@trr.metro.NET) wrote:
> On Sat, 21 Mar 1998, Tobias Richter wrote:
> > Your facsimile job to 02319922959 was not sent because:
> >     Failure to train at 2400 bps or +FMINSP value
> > 
> >     ---- Transcript of session follows ----
> > Mar 21 02:32:07.20: [25043]: SESSION BEGIN 00000466 492319922959
> > Mar 21 02:32:07.20: [25043]: SEND FAX: JOB 62 DEST 02319922959 COMMID 00000466
> > Mar 21 02:32:07.20: [25043]: DELAY 2600 ms
> > Mar 21 02:32:09.81: [25043]: <-- [17:ATX3E0V1Q0S0=0H0\r]
> > Mar 21 02:32:10.02: [25043]: --> [16:ATX3E0V1Q0S0=0H0]
> > Mar 21 02:32:10.02: [25043]: --> [2:OK]
> > Mar 21 02:32:10.02: [25043]: <-- [21:ATS8=2S7=60&E4&D3&C1\r]
>                                                      ^^^^^^
> This may not fix your problem but be aware that &D3 is broken on
> the MT2834 modems. The workaround is to use &C4 in place of &C1.
>
> [snip]

So I just changed 
	ModemSetupDCDCmd:       AT&C4
but left alone
	ModemSetupDTRCmd:       AT&D3
correct?

But you were right. It didn't fix the original problem, 
I still get the same error.

More hints appreciated,
tobias