flexfax: v4.0pl2 not sending pages

[Rob Misiak <rob@iagnet.net>]

Hi,

I'm using HylaFax v4.0pl2 on a FreeBSD/i386 2.2.5 box - the modem is
a Multitech MT1932ZDX (which I purchased specifically for use with HylaFax).

I'm attempting to configure the machine to send out-going faxes only. I
have faxq and hfaxd running:

% ps -aux | grep faxq; grep ^hyla /etc/inetd.conf
fax      10754  0.0  7.6   520  792  ??  Is    8:41PM    0:00.11 faxq
hylafax stream  tcp     nowait  fax     /usr/local/sbin/hfaxd      hfaxd -I

sendfax will queue faxes just fine; however, faxq is never sending them (it
isn't even dialing in the first place).  When I try to manually run the queue
using faxsend, the modem will dial and establish a connection with the fax
machine, and then report that the remote machine has hung up:

Mar 03 20:21:37.11: [10642]: REMOTE best 20 ms, 10 ms/scanline
Mar 03 20:21:37.11: [10642]: USE 9600 bit/s
Mar 03 20:21:37.11: [10642]: USE 20 ms, 10 ms/scanline
Mar 03 20:21:37.11: [10642]: <-- [5:ATH0\r]
Mar 03 20:21:38.71: [10642]: --> [7:+FHNG:2]
Mar 03 20:21:38.71: [10642]: REMOTE HANGUP: Call aborted,  from +FK or <CAN> (code 2)
Mar 03 20:21:39.39: [10642]: --> [2:OK]
Mar 03 20:21:39.41: [10642]: SESSION END

I've tried completely re-installing and re-configuring HylaFax from scratch.
However, it isn't working.

A manpage from www.vix.com says that faxq has a -m option. I tried using this
too, but faxq does not recognise it.

I've toyed with the configuration; however, currently it is restored to the
default for a MT1932ZDX modem. The only thing that is changed is ModemDialCmd
is "ATDT9,%s@" in my config.cuaa0.

I suspect that whatever the problem is, is very stupid and a complete over-look
on my part :) Any help that could be offered would be greatly appreciated;
right now I am going to try going to an earlier version.

         Rob