Re: flexfax: Still having problems with Zyxel 1496

[Phil Watkinson <pkw@elgro.co.uk>]

At 12:57 14/10/1997 +0100, Andy wrote:
>[snip]
>Class2DCCQueryCmd:      "!(0,1),(0-7),(0-4),(0-2),(0),(0),(0),(0-7)"
>
>which doesn't work either. 
>Is there any description of the Class2DCCQueryCmd that is more
>informational than just "use this one if you have trouble with..." ?
>
>[snip]

Yes, in the html docs, the chapter "Advanced Server Configuration", and
there's a whole section about it entitled "Modems that Lie about their
Capabilities".

Also there, in the Modems chapter, is a full page on the ZyXEL 1496, which
altho' a bit dated, recommends this modem *if* the firmware revision is
v6.13 or later.

Unfortunately I cannot see anything specific about your 'error after
issuing the MPS command' in the docs.

Good luck, and I hope you get it sorted,

Cheers,
Phil Watkinson,
Boston, UK.