Re: flexfax: Help: IXO/TAP problem

[Matthias.Apitz@SOFTCON.de]

Paulo Noel Martins wrote:
    
    
    Thanks for any help...
    
    Paulo Noel Martins
    CC - FCUP
    
    Version 4.0pl Linux gcc 2.7.2 USRobotics Courier Dual Standard
    V34 Fax with V32Bis 
                
    
    
    Your pager job to 0943800800 failed because:
        Unknown problem (check modem power); too many attempts to dial
    
        ---- Transcript of session follows ----
    
    Aug 29 17:54:51.42: [14282]: SESSION BEGIN 00000016 35120943800800
    Aug 29 17:54:51.42: [14282]: SEND PAGE: JOB 43 DEST 0943800800 COMMID 00000016
    Aug 29 17:54:51.42: [14282]: MODEM set DTR OFF
    Aug 29 17:54:51.42: [14282]: DELAY 2600 ms
    Aug 29 17:54:54.03: [14282]: MODEM set DTR ON
    Aug 29 17:54:54.03: [14282]: MODEM set baud rate: 38400 baud, input flow NONE, output flow NONE
    Aug 29 17:54:54.03: [14282]: MODEM flush i/o
    Aug 29 17:54:54.03: [14282]: <-- [17:ATE0V1Q0X4S0=0H0\r]
    Aug 29 17:54:54.20: [14282]: --> [16:ATE0V1Q0X4S0=0H0]
    Aug 29 17:54:54.20: [14282]: --> [2:OK]
    Aug 29 17:54:54.20: [14282]: <-- [32:ATS8=2S7=60&H0&I0&R1S13=1&D2&C1\r]
    Aug 29 17:54:54.37: [14282]: --> [2:OK]
    Aug 29 17:54:54.37: [14282]: <-- [5:ATM0\r]
    Aug 29 17:54:54.54: [14282]: --> [2:OK]
    Aug 29 17:54:54.54: [14282]: MODEM set parity: 7 bits, even parity
    Aug 29 17:54:54.54: [14282]: MODEM input buffering enabled
    Aug 29 17:54:54.54: [14282]: <-- [12:AT+FCLASS=0\r]
    Aug 29 17:54:54.69: [14282]: --> [2:OK]
    Aug 29 17:54:54.69: [14282]: <-- [4:ATZ\r]

Did you set ATZ for PagerSetupCmds? ATZ re-enables the echo mode
and pagesend(1M) doesn't know what to do with the echo of the
ATDT0943800800 while it's waiting for CONNECT.

	matthias

    Aug 29 17:54:55.10: [14282]: --> [2:OK]
    Aug 29 17:54:55.10: [14282]: <-- [6:AT&N2\r]
    Aug 29 17:54:55.37: [14282]: --> [5:AT&N2]
    Aug 29 17:54:55.37: [14282]: --> [2:OK]
    Aug 29 17:54:55.37: [14282]: DIAL 0943800800
    Aug 29 17:54:55.37: [14282]: <-- [15:ATDT0943800800\r]
    Aug 29 17:55:25.22: [14282]: --> [14:ATDT0943800800]
    Aug 29 17:55:25.22: [14282]: PAGE FAILED: Unknown problem (check modem power)
    Aug 29 17:55:25.22: [14282]: PAGE FAILED: Unknown problem (check modem power); too many attempts to dial
    Aug 29 17:55:25.22: [14282]: <-- [5:ATH0\r]
    Aug 29 17:55:25.22: [14282]: --> [16:CONNECT 1200/ARQ]
    Aug 29 17:55:30.22: [14282]: MODEM TIMEOUT: reading line from modem
    Aug 29 17:55:30.22: [14282]: MODEM <Timeout>
    Aug 29 17:55:30.22: [14282]: MODEM input buffering enabled
    Aug 29 17:55:30.22: [14282]: MODEM set DTR OFF
    Aug 29 17:55:30.22: [14282]: SESSION END