HylaFAX The world's most advanced open source fax server

[Date Prev][Date Next][Thread Prev][Thread Next] [Date Index] [Thread Index]

pager nro 411 para 6223315 falhou (fwd)



Hi all. I still can not send pages using sendpage. I can send fax using
faxmail,sendfax,etc but not pages.  I have tried with two diferent paging
companies (one of them in other city where a friend of mine successfully
sent pages using sendpage) and got the same result.

I will include both the log and the setup.modem.  It seems to me that this
is a ATSomething that I am missing or miscofiguring. If anyone uses such
modem or has a tip, please send me! :)

LOG :

Seu pager para 6223315 falhou por que :
    No initial ID response from paging central; too many attempts to send

    ---- Transcript of session follows ----

Feb 07 15:27:03.97: [ 5971]: SESSION BEGIN 00000854 55926223315
Feb 07 15:27:03.97: [ 5971]: SEND PAGE: JOB 411 DEST 6223315 COMMID 00000854
Feb 07 15:27:03.97: [ 5971]: MODEM set DTR OFF
Feb 07 15:27:03.97: [ 5971]: DELAY 2600 ms
Feb 07 15:27:06.58: [ 5971]: MODEM set DTR ON
Feb 07 15:27:06.76: [ 5971]: MODEM set baud rate: 38400 baud, input flow RTS/CTS, output flow RTS/CTS
Feb 07 15:27:06.77: [ 5971]: MODEM flush i/o
Feb 07 15:27:06.77: [ 5971]: <-- [17:ATE0V1Q0X4S0=0H0\r]
Feb 07 15:27:06.94: [ 5971]: --> [16:ATE0V1Q0X4S0=0H0]
Feb 07 15:27:06.94: [ 5971]: --> [2:OK]
Feb 07 15:27:06.94: [ 5971]: <-- [32:ATS8=2S7=60&H1&I0&R2S13=1&D2&C1\r]
Feb 07 15:27:07.12: [ 5971]: --> [2:OK]
Feb 07 15:27:07.12: [ 5971]: <-- [5:ATM1\r]
Feb 07 15:27:07.29: [ 5971]: --> [2:OK]
Feb 07 15:27:07.29: [ 5971]: MODEM set parity: 8 bits, no parity
Feb 07 15:27:07.29: [ 5971]: MODEM input buffering enabled
Feb 07 15:27:07.32: [ 5971]: <-- [12:AT+FCLASS=0\r]
Feb 07 15:27:07.47: [ 5971]: --> [2:OK]
Feb 07 15:27:07.47: [ 5971]: <-- [15:AT&A0&K0&M0&N2\r]
Feb 07 15:27:07.74: [ 5971]: --> [2:OK]
Feb 07 15:27:07.74: [ 5971]: DIAL 6223315
Feb 07 15:27:07.74: [ 5971]: <-- [12:ATDT6223315\r]
Feb 07 15:27:25.52: [ 5971]: --> [12:CONNECT 1200]
Feb 07 15:27:25.52: [ 5971]: EXPECT ID (paging central identification)
Feb 07 15:27:27.52: [ 5971]: MODEM TIMEOUT: reading line from modem
Feb 07 15:27:27.52: [ 5971]: RECVunknown paging central response: 
Feb 07 15:27:29.52: [ 5971]: MODEM TIMEOUT: reading line from modem
Feb 07 15:27:29.52: [ 5971]: RECVunknown paging central response: 
Feb 07 15:27:31.52: [ 5971]: MODEM TIMEOUT: reading line from modem
Feb 07 15:27:31.52: [ 5971]: RECVunknown paging central response: 
Feb 07 15:27:33.52: [ 5971]: MODEM TIMEOUT: reading line from modem
Feb 07 15:27:33.52: [ 5971]: RECVunknown paging central response: 
Feb 07 15:27:35.52: [ 5971]: MODEM TIMEOUT: reading line from modem
Feb 07 15:27:35.52: [ 5971]: RECVunknown paging central response: 
Feb 07 15:27:35.52: [ 5971]: PAGE FAILED: No initial ID response from paging central
Feb 07 15:27:35.52: [ 5971]: PAGE FAILED: No initial ID response from paging central; too many attempts to send
Feb 07 15:27:35.52: [ 5971]: <-- [5:ATH0\r]
Feb 07 15:27:40.52: [ 5971]: MODEM TIMEOUT: reading line from modem
Feb 07 15:27:40.52: [ 5971]: MODEM <Timeout>
Feb 07 15:27:40.52: [ 5971]: MODEM input buffering enabled
Feb 07 15:27:40.52: [ 5971]: MODEM set DTR OFF
Feb 07 15:27:40.52: [ 5971]: SESSION END

    ---- Fax nao enviado ----

      Destinatario: 6223315
             JobID: 411
           GroupID: 411
         Remetente: Mario de Mello Bittencourt Neto
            E-mail: mneto@zeus.buriti.com.br
            CommID: 00000854
Submetido a partir: localhost
            Status: No initial ID response from paging central; too many attempts to send
           Dialogs: 3 (exchanges with remote device)
        Tentativas: 0 (ligacoes consecutivas falhas ao destinatario)
          Ligacoes: 3 (total de ligacoes efetuadas)

    ---- Pagers submetidos a transmissao e nao enviados ----

       PIN 2578

    ---- Messagem ----

me ligues no telefone 6332630

CONFIG.MODEM

CountryCode:            55
AreaCode:               92
FAXNumber:              6333053
LongDistancePrefix:     0
InternationalPrefix:    00
DialStringRules:        "etc/dialrules"
ServerTracing:          1
SessionTracing:         15
RecvFileMode:           0600
LogFileMode:            0600
DeviceMode:             0600
RingsBeforeAnswer:      1
SpeakerVolume:          medium
GettyArgs:              "-h %l dx_%s"
LocalIdentifier:        "Argo Internet Provider"
TagLineFont:            etc/lutRS18.pcf
TagLineFormat:          "From %%l|%c|Page %%p of %%t"
PercentGoodLines:       90
MaxRecvPages:           10
ModemType:              Class2.0        # use class 2.0 interface
ModemRate:              38400           # DCE-DTE communication rate
ModemFlowControl:       rtscts          # XON/XOFF flow control assumed
ModemNoFlowCmd:         AT&H0&I0&R1     # setup modem for no flow control
ModemHardFlowCmd:       AT&H1&I0&R2     # setup modem for hardware flow control
ModemSoftFlowCmd:       AT&H2&I2&R1     # setup modem for software flow
ModemSetupDTRCmd:       ATS13=1&D2      # setup so DTR drop resets modem
ModemSetupDCDCmd:       AT&C1           # setup so DCD reflects carrier (or not)
ModemResultCodesCmd:    ATQ0X4          # enable extended result
ModemSetupAACmd:        AT+FAA=1
ModemSetVolumeCmd:      "ATM0 ATM1 ATM1 ATM1 ATM1"
Class2BUGCmd:		AT+FBU=0
Class2CQQueryCmd:       !(0),(0)        # override modem response

* My friend sent me these lines. *
PagerSetupCmds:         AT&A0&K0&M0&N2
PagerTTYParity:         none
IXOMaxUnknown:          5
IXOIDProbe:             2
IXOIDTimeout:           10
IXOLoginRetries:        5

Thanks.




Project hosted by iFAX Solutions